1. Purchasing requirements The thickness of the panel is normally between 1.95-2.15cm:

2. The thickness of the purchased light board can be 1.90-2.1cm and the gloss is above 85:

3, the big trim process notes:

(1) Blocks ought to be placed firmly and smoothly around the platform.

(2) Understand and start to see the large cut-off schematic diagram of the stone.

(3) The large-cut size correction and review before the lower knife ought to be careful and accurate.

(4) After cutting the first three pieces of the block, 1st stop and knock from the initial stone skin to check the quality of the block: whether there are any defects such as for example dark splits, color gall, stains, and color lines; Whether the thickness is within the allowable tolerance (20mm �� 5mm) and timely correction

(5) Machine inspection, maintenance cleaning and cleaning work should be done before and following operation.

(6) Complement: It is advisable to cut (height) as well as thickened plates, specifically for stone with grain.

4, the thickness of the process notes:

(1) The actual thickness after thickness setting is 19.5-2.0 cm. Work with a vernier caliper to check on the thickness.

(2) Be cautious when handling. Pay attention to safety and steer clear of harm to the sheet.

(3) Machine inspection, maintenance cleaning and cleaning function should be done before and Granite Flooring Tiles after operation.

5, large surface area polishing process notes:

(1) Please fill in the glue before polishing, complete the gap between the stone dish (especially China Granite Marble Stone, simply click the up coming post,), and prevent looking forward to the finished item to spend a lot of manpower for the beauty glue.

(2) The polishing process is performed by using a full set of resin abrasives.

(3) Gloss of 85 or even more.

(4) Take the time to avoid inadvertent harm to the sheet when lifting the plank.

(5) The sides should be floor as well as the gloss ought to be enough.

6, the bridge shear process notes:

(1) To slice the face up.

(2) The saw blade should be sharp. (The blade can be sharpened before the knife is trim)

(3) To regulate the lower blade and cutting velocity.

(4) There has to be a machining allowance. (The rest of the amount is certainly 3-4mm, as well as the seam is defined to within 0.3mm when used for 1/2 round setting).

(5) If the natural stone with grain is to be cut out together with the thickened part, the texture of the large surface as well as the thickened edge will be right, as well as the finished product will be gorgeous and natural.

(6) Stay away from the phenomenon of missing edges, missing corners, not completely trim, cutting, and wrong size.

(7) Machine inspection, maintenance, cleaning and cleaning function should be completed before and after operation.

7. Gluing and setting process:

(1) To make the coloring carefully, try to adjust the glue to the essential and stone color.

(2) The large plate and the solid plate ought to be as close as you possibly can. After the adhesion, fix the clip with iron and fix it to make it glue.

(3) Gluing with a sheet that is in touch with the anastomosis before gluing.

(4) The seam after gluing is not more than 0.3mm.

(5) When gluing, be careful to scrape the excess glue when the glue is still dry, to avoid spending a lot of manpower over the glue through the cosmetic process.